Tubing Supplies

These plastic mainline tees are designed to connect a combination of two different size mainlines into one mainline. The aggressive hose barbs lock on to the plastic mainline tubing or black plastic water pipe once a hose clamp is tightened down. Designed for common water pipe sizes.

This plastic tee has aggressive hose barbs to lock on for a leak free hold once the plastic mainline tubing or black plastic water pipe is clamped on with a hose clamp.  Sized to fit common water pipe sizes, these tees allow two separate lines to be connected into one.

Use two when extra holding is desired

Packages of 25

Sold individually

The Quick Seal Mainline Entrance Fitting is the first mainline entrance fitting that actually is designed to fit polyethylene tubing. The fitting has the flexibility to fit around tubing that is not perfectly round. This fitting is not designed for use with black plastic water line. So simple to install! Just drill a hole in the top of the mainline, insert the gasket and attach the fitting. Done! then you can easily attach the Quick Seal Mainline Entrance Fitting to your lateral line anchor (hooked connector).

Sold individually or bags of 50.

Bag of 100

With spooler, 600' per spool

A Sight Level takes the guesswork out of laying tubing and helps you keep a constant 4% minimum pitch in your tubing. Ideal for preliminary survey and simple distance estimation. Sturdy impact resistant body and easy-to-read protected vial. Includes instruction manual and pocket clip.

• Built in tubing spreader
• Auto locking vise grips
• Assemble drop lines
• Repair lateral line
• Install 5/16" fittings

Bag of 50

This spinning spooler has an adjustable brake to control over-spin when you stop pulling the wire.

Redesigned for better performances, our new connector has a more durable shape, and larger barbs, to increase the grip for permanent installation.

Bag of 100

Clear or Black Stub Adapter

Bag of 100

Bags of 100

Redesigned to work with newer poly tubing. Spout plug for use with 5/16" tubing and stubby spout. Increased inside diameter for more capacity.

Bag of 100

12 1/2" or 9 Gauge Wire Tensioning Device

Tension should be let off after season. Vertical slats should be installed around trees that the wire fastens to. When the slats deteriorate, replace them in a different location on the tree. Better yet, move them every couple years.

• Special fork for least amount of damage to spout/tap/spile/spigot
• Prevents damage to spout/tap/spile/spigot
• Special head prevents damage to tree bark
• Fits in most tool belts
• Predrilled hole for cord attachment(not included)

Bag of 100

a 5/16" tubing cutter that is small and efficient

• All Stainless Steel Parts
• No assembly required
• Special hanger works with mainline up to 2"
• Hold one 500' roll of 5/16" tubing
• Spooler spins freely so tubing will not kink or get stretched

7/16"

Bag of 100

A support snap-on fitting, to tie to, to hold up long lines of tubing to prevent sags. Pull up at an angle to prevent sags. A very useful part.

handy tubing tool

Packages of 10

For part #27. 

It can also be used to release tension on the wire after the season.

To hold main line tubing to aerial wires, galvanized, 1000/coil

Leader mainline Y's are designed to optimize flow of two mainlines joining together with a barbed fitting designed to insert into the end of the mainlines and be secured with a hose clamp over the mainline tightening the plastic mainline down onto the barbs so that the pipe has a secure hold and a leak proof seal. These Y's are common water pump sizes 1/2", 3/4", and 1" for all plastic mainline tubing and black plastic water pipe.